| Outside diameter D | 68 (mm) |
| Height H | 12 (mm) |
| Utilization design | Quick-change system |
Quick change system consisting of only three parts for short set-up times for new machine layouts
Sealing frame made of low-marking material that can be exchanged without tools
Quick cleaning during layout changes, as base remains permanently on the machine table
Very high holding forces on dry, moist glass
Working heights and interference contour suitable for mixed operation with original equipment vacuum blocks
Design
Design
- Suction cup with sealing frame (1) made of HT1-material leaving few marks
- Square and round suction areas available (2)
- Aluminum housing with break joint (3)
- Mono-Base with hollow bolt for long-term mounting on a machine table (5)
- Cover (4) for bases that are not equipped with suction cups
Technical Data
Technical Data
- Three-part quick-change system
- Hose-free vacuum line
- Fits machine tables with M12 vacuum feeds
Documentation
Documentation
The matching documentation for this product is available in this section.
| Documents | Language |
|---|---|
| Vietnamese |
The documentation is also fully available in English.
| Documents | Language |
|---|---|
| English |
1 - 4 from 4 results
- PHASE-OUT ITEM
Part no.: 10.01.18.01031
Quick change Mono Base for automated clamping
| Outside diameter D | 62.9 (mm) |
| Height H | 18 (mm) |
| Thread G1 | M12-M |
| Utilization design | Quick-change system |
| Outside diameter D | 80 (mm) |
| Height H | 102 (mm) |
| Utilization design | Quick-change system |
| Material | Aluminum |
| Material workpiece support | ED |
| Material hardness [Shore A] | 85 (Shore A) |
| Sealing material | High temp material HT1 |
| Outside diameter D | 80 (mm) |
| Height H | 62 (mm) |
| Utilization design | Quick-change system |
| Material | Aluminum |
| Material workpiece support | ED |
| Material hardness [Shore A] | 85 (Shore A) |
| Sealing material | High temp material HT1 |